China 1.14 inch IPS 135*240 SPI 13PIN Manufacturers, Suppliers, Factory

Overheating of the LCD screen may accelerate component aging (such as shortening the screen lifespan). In severe cases, it may cause deformation of the plastic casing, damage to the circuit insulation, and even risk fire. If abnormal overheating cannot be alleviated by the above methods, it is recommended to immediately discontinue use and send the device for repair.

Shenzhen Hongjia Technology has been professionally engaged in the research and development, production and sales of 1.14-inch to 10.1-inch display screens and supporting touch screens for 12 years, including consumer electronic display screens, industrial display screens, military display screens, medical display screens and outdoor sunlight-readable display screens, etc. The 3.97-inch outdoor readable display screen is semi-reflective and semi-transparent, with a resolution of 480*800, supports RGB interface and MIPI interface, uses the conventional ST7701 driver IC, has a stable supply, and can also be customized.

After VGA, QVGA, WVGA, and HVGA resolution products were gradually born. These resolutions can be seen everywhere in the mobile phone parameters. The following is the explanation and difference of VGA, QVGA, WVGA, and HVGA.

Usually, touchable LCD screens are capacitive screens, and the positioning method of the touch screen is through the electric field. Therefore, when static electricity and discharge occur, the LCD touch screen will have a "drift" screen effect, that is, the click position is offset from the actual response position.

LCD screen itself has problems. If it is indeed the screen itself that is at fault after testing with relevant instruments, in addition to replacing a new LCD screen, the device-related software should be debugged and optimized so that the screen can work with the motherboard's CPU. The best way is to increase the OSC frequency of the IC and see how the LCD screen flickers. Of course, if the TFT LCD screen has separate row and column drivers, you can also adjust it by setting the driver chip.

Backlighting is used in small, light, flat-panel liquid crystal displays (LCDs) and other electronic devices that require backlighting, including handheld devices as small as the palm of your hand, and large-screen TVs. The goals of backlight design include low power consumption, ultra-thin, high brightness, uniform brightness, large area, and control of different width and narrow viewing angles. To achieve these challenging design goals with controlled cost and rapid implementation, computer-aided optical design tools must be used for design. This article introduces the characteristics of LightTools optical design and analysis software from ORA Company in the United States, which can be used to develop the most advanced backlight design applications today.